Loos & Co. Cable Crimps 11+35 and 4-way Impact 3/16? 1/4? Cable Crimper Binder!!

Description

Loos & Co. Cable Crimps 11+35 and 4-way Impact 3/16? 1/4? Cable Crimper Binder!!!
This appears to be a tool for joining wire rope and metal cable together in an "X". I honestly don't know EXACTLY what this 4-way crimping clasping tool is called or if the tool is made by Loos & Co. I also don't know the exact size or composition of the cable that is used. There are no part numbers visible.
If you know what it is called or have any info on it, please message me. All measurements are approximate. This tool is heavier than it looks at about 13-14lbs.
The crimping tool is in good, usable condition with a tiny bit of surface rust here and there. Approximate dimensions of the red "anvil" are 4" dia. x 5" high with 3/8" wide slots. There is tape and/or label residue on the outside.
The lower die is held in place in the anvil with a set screw. The channels are about 1/4" across. About 2" in dia.
The upper die/ram is about 2-1/4" in diameter with about 5/16" channels. Overall height of the ram is about 7". It appears that it would be struck with a sledge hammer to crimp the connectors or you could probably use a press.
The crimps are new and were mixed together in a bag with the label on it--I don't know what part the number corresponds to of which part of the 2-piece, top and bottom crimps. I think they are stainless. There are 11 of the "outer" crimps and at least 35 of the smaller, "inner" crimps, I think I counted 38. I'm not sure which goes in the top or bottom of the tool.
Sold AS-IS. Shipping is actual via FedEx Ground/Home or your choice of carrier.
Your positive feedback will get ours... :-)